Refine
Document Type
- Article (15) (remove)
Keywords
- Argania spinosa (2)
- Bodenwasser (2)
- Marokko (2)
- Satellitenfernerkundung (2)
- gypsum plaster (2)
- AFD (1)
- Abwasser (1)
- AfD (1)
- Anemometrie (1)
- Antarktis (1)
Institute
- Fachbereich 6 (15) (remove)
Addition of Phosphogypsum to Fire-Resistant Plaster Panels:
A Physic–Mechanical Investigation
(2023)
Gypsum (GPS) has great potential for structural fire protection and is increasingly used in construction due to its high-water retention and purity. However, many researchers aim to improve its physical and mechanical properties by adding other organic or inorganic materials such as fibers, recycled GPS, and waste residues. This study used a novel method to add non-natural GPS from factory waste (phosphogypsum (PG)) as a secondary material for GPS. This paper proposes to mix these two materials to properly study the effect of PG on the physico-mechanical properties and fire performance of two Tunisian GPSs (GPS1 and GPS2). PG initially replaced GPS at 10, 20, 30, 40, and 50% weight percentage (mixing plan A). The PGs were then washed with distilled water several times. Two more mixing plans were run when the pH of the PG was equal to 2.4 (mixing plan B), and the pH was equal to 5 (mixing plan C). Finally, a comparative study was conducted on the compressive strength, flexural strength, density, water retention, and mass loss levels after 90 days of drying, before/after incineration of samples at 15, 30, 45, and 60 min. The results show that the mixture of GPS1 and 30% PG (mixing plan B) obtained the highest compressive strength (41.31%) and flexural strength (35.03%) compared to the reference sample. The addition of 10% PG to GPS1 (mixing plan A) improved fire resistance (33.33%) and the mass loss (17.10%) of the samples exposed to flame for 60 min compared to GPS2. Therefore, PG can be considered an excellent insulating material, which can increase physico-mechanical properties and fire resistance time of plaster under certain conditions.
Because EU water quality policy can result in infrastructure creation or adaptation at the local level across member states, compliance cases are worth examining critically from a sustainable spatial planning perspective. In this study, the 2000 EU Water Framework Directive’s (WFD) reach to local implementation efforts in average towns and cities is shown through the case study of nonconforming household wastewater infrastructure in the German state of Rhineland Palatinate. Seeing wastewater as a socio-technical infrastructure, we ask how the WFD implementation can be understood in the context of local infrastructure development, sustainability, and spatial planning concepts. In particular, this study examines what compliance meant for the centralization or decentralization of local wastewater infrastructure systems—and the sustainability implications for cities
from those choices.
Background: Increasing exposure to engineered inorganic nanoparticles takes actually place in both terrestric and aquatic ecosystems worldwide. Although we already know harmful effects of AgNP on the soil bacterial community, information about the impact of the factors functionalization, concentration, exposure time, and soil texture on the AgNP effect expression are still rare. Hence, in this study, three soils of different grain size were exposed for up to 90 days to bare and functionalized AgNP in concentrations ranging from 0.01 to 1.00 mg/kg soil dry weight. Effects on soil microbial community were quantified by various biological parameters, including 16S rRNA gene, photometric, and fluorescence analyses.
Results: Multivariate data analysis revealed significant effects of AgNP exposure for all factors and factor combinations investigated. Analysis of individual factors (silver species, concentration, exposure time, soil texture) in the unifactorial ANOVA explained the largest part of the variance compared to the error variance. In depth analysis of factor combinations revealed even better explanation of variance. For the biological parameters assessed in this study, the matching of soil texture and silver species, and the matching of soil texture and exposure time were the two most relevant factor combinations. The factor AgNP concentration contributed to a lower extent to the effect expression compared to silver species, exposure time and physico–chemical composition of soil.
Conclusions: The factors functionalization, concentration, exposure time, and soil texture significantly impacted the effect expression of AgNP on the soil microbial community. Especially long-term exposure scenarios are strongly needed for the reliable environmental impact assessment of AgNP exposure in various soil types.
Formulations of macrocyclic lactone anthelmintics such as moxidectin are regularly administered to sheep to combat parasites. A disadvantage of these pharmaceuticals are their side effects on non-target organisms when entering the environment. Little is known about anthelmintic effects on plant reproduction and whether the effects depend on environmental factors. For ecological and methodological reasons, we aimed at testing whether temperature affects the efficacy of a common moxidectin-based formulation on seed germination. We carried out a germination experiment including three typical species of temperate European grasslands (Centaurea jacea, Galium mollugo, Plantago lanceolata). We applied three temperature regimes (15/5, 20/10, 30/20°C), and a four-level dilution series (1:100–1:800) of formulated moxidectin (i.e., Cydectin oral drench). These solutions represent seed-anthelmintic contacts in the digestive tract of sheep shortly after deworming. In addition, a control was carried out with purified water only. We regularly counted emerging seedlings and calculated final germination percentage, mean germination time and synchrony of germination. Formulated moxidectin significantly reduced percentage, speed and synchrony of germination. A 1:100 dilution of the formulation reduced germination percentage by a quarter and increased mean germination time by six days compared to the control. Temperature moderated effects of the anthelmintic drug on germination in all response variables and all species, but in different patterns and magnitudes (significant anthelmintic x temperature x species interactions). In all response variables, the two more extreme temperature regimes (15/5, 30/20°C) led to the strongest effects of formulated moxidectin. With respect to germination percentage, G. mollugo was more sensitive to formulated moxidectin at the warmest temperature regime, whereas P. lanceolata showed the highest sensitivity at the coldest regime. This study shows that it is important to consider temperature dependencies of the effects of pharmaceuticals on seed germination when conducting standardised germination experiments.
Finding behavioral parameterization for a 1-D water balance model by multi-criteria evaluation
(2019)
Evapotranspiration is often estimated by numerical simulation. However, to produce accurate simulations, these models usually require on-site measurements for parameterization or calibration. We have to make sure that the model realistically reproduces both, the temporal patterns of soil moisture and evapotranspiration. In this study, we combine three sources of information: (i) measurements of sap velocities; (ii) soil moisture; and (iii) expert knowledge on local runoff generation and water balance to define constraints for a “behavioral” forest stand water balance model. Aiming for a behavioral model, we adjusted soil moisture at saturation, bulk resistance parameters and the parameters of the water retention curve (WRC). We found that the shape of the WRC influences substantially the behavior of the simulation model. Here, only one model realization could be referred to as “behavioral”. All other realizations failed for a least one of our evaluation criteria: Not only transpiration and soil moisture are simulated consistently with our observations, but also total water balance and runoff generation processes. The introduction of a multi-criteria evaluation scheme for the detection of unrealistic outputs made it possible to identify a well performing parameter set. Our findings indicate that measurement of different fluxes and state variables instead of just one and expert knowledge concerning runoff generation facilitate the parameterization of a hydrological model.